After months of trying to locate a supply of carbon fibre cored, stainless helically wound ignition wire for the MSD ignition system fitted to the drag bike, I eventually found a source in this country. Spent a few hours replacing the leads, now 8 mm silicon, marking them up and crimping the terminals on with my new lead crimpers. All ready now for another start attempt.
Box of goodies.
IMG_0001.JPG (2.46 MiB) Viewed 32796 times
New and old leads compared
IMG_0002.JPG (1.32 MiB) Viewed 32796 times
Printed lead numbers
IMG_00102.JPG (2.45 MiB) Viewed 32796 times
Leads fitted with numbers and heat shrink
IMG_0003.JPG (1.6 MiB) Viewed 32796 times
Mallory distributor fitted with new leads
IMG_0004.JPG (2.43 MiB) Viewed 32796 times
Nest of vipers!
IMG_0005.JPG (1.82 MiB) Viewed 32796 times