With the help of my niece a couple of weeks ago, we had another go at starting the bike with the new beefier starter handle fitted. Firstly we found fuel was not getting to the rear carbs so a new fuel tap bracket was made to get it lower than the tank outlet. Spinning it over we had a couple of coughs and flames from the front exhausts as the fuel ignited but no start,so the ignition timing needs to be gone over again from the start to check that it's set up correctly. We also noticed that the belt tensioner had bent the inner engine plate allowing the belt to become slack. A new arrangement with an outrigger support is now being made.......plenty of time on my hands to get round to do stuff like this. Unfortunately I don't think Dragstalgia will be taking place in July which has been the target we have been working towards. Hope everyone out there keeps well and see you at the strip when all this is over!!